Matrox M.Key/100 Manual de instalación descargar pdf (Pagina 19)

Chapter2　Installing Windows Server 2008

Manual OS Installation

2.1.2 Configuring Array

When you operate with array configurations, configure arrays first before you install OS.

1 Turn on the server.

2 Configure an array.

The method differs depending on your array controller.

For Onboard Software RAID (Embedded MegaRAID SATA)

When the following message appears, press the [Ctrl] + [M] keys or the [Enter] key.

SATA Setup Utility starts up, and Management Menu appears.

For details, refer to "Embedded MegaRAID SATA User's Guide" in Array Controller Document & Tool CD.

For SAS controller card or onboard IM (Integrated Mirroring SAS)

When the following message appears, press the [Ctrl] + [C] keys.

BIOS Utility starts up.

For details, refer to "Integrated Mirroring SAS User's Guide" in Array Controller Document & Tool CD.

For SAS array controller card (MegaRAID SAS)

When the following message appears, press the [Ctrl] + [H] keys.

WebBIOS starts up.

For details, refer to "MegaRAID SAS User's Guide" in Array Controller Document & Tool CD.

3 Turn off the server.

2.1.3 Cautions for unconfigured array

When a SAS array controller card has been installed when not building an array using PRIMERGY

ECONEL100 S2, change the BIOS setting [SATA RAID Enable] to "Disabled".

The installation is not normally completed if it doesn't change to "Disabled".

SAS Ctrl (PG-224B/PG-228B) Install it from PCI-Express SAS Card Document & Tool CD.

Other expansion card Driver attached with each expansion card

Press Ctrl-M or Enter to run LSI Software RAID Setup Utility.

Press Ctrl C to start LSI Logic Configuration Utility

Press <Ctrl><H> for WebBIOS

Onboard LAN / Expansion card Driver

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 47 48

Sin comentarios

Matrox M.Key/100 Manual de instalación Pagina 19